Magic Caliper for Android – Latest Version & Features

This app requires the MAG-ic Probe BLE thickness caliper from MAG-ic Technologies at www.magicprobe.net.
Using this app you can connect to the MAG-ic Probe thickness caliper and view measurements on your Android device in millimeters or thousands of an inch.
After opening the app will automatically try to connect to the MAG-ic Probe and initiate the calibration sequence.
Once completed the measurement will be displayed until power is removed from the MAG-ic Probe or the app is closedSteps:1.
Open the Magic Caliper application.2.
Connect power, or reset power, to your MAG-ic Probe.3.
Follow the instructions on screen to calibrate (save time by attaching the magnet when you power on the MAG-ic Probe), works with both the accompanying spherical and cylindrical magnets.4.
Begin measuring!Accuracy: - This app does not implement the low-level calibration or interpret the data from the MAG-ic Probe, those functions are internal to MAG-ic Probe.
The app displays the calibrated measurements via Bluetooth Low Energy on your device.Features: - The app supports landscape orientation with a larger font so you can view the measurements from a distance- The app can display in mm or inches (mil) by toggling the switch at the top of the screen - The app will display either a cylinder or sphere in the top left corner depending on what magnet you use when going through the calibration steps - The display includes a sliding bar that shows you the relative distances from zero until the end of the range based on the magnet used- Once measuring, the app will prevent the screen from sleeping so that you can view the measurements hands-free - You can navigate away or minimize the app and return during the measurement process - If the signal is interrupted from the probe or the probe has power removed a notice will appear indicating loss of connection and reset the application back to the start.
How to use the App:After power on the MAG-ic probe requires a calibration sequence.
The App will guide you through the process.
This is the process the App will take you through to connect and take measurements:1.
Open the app and then either apply power or remove and apply power to the MAG-ic Probe.
The Probe will only connect to the app for a few seconds after power-on.2.
The app will prompt you to attach a magnet to the probe.
If one is already attached it will automatically start the calibration process.
Otherwise, attach the magnet as instructed.3.
A progress bar will show the remaining to complete calibration.
The duration is about 8-10 seconds.4.
A prompt will appear to remove the magnet.
Remove the magnet and hold at least 30cm/12" away.
A progress bar will count down again.
The duration is about 8-10 seconds.5.
The screen will transition to the measurement screen, measurements are provided about every 1/10th of a second from the MAG-ic Probe.Bug Reporting: - Version 1.0 was developed with MAG-ic Probe Firmware 1.1.0.
- Please help me make this app better.
If you discover an issue or have any problems, contact the email in the information section of the app (click on the i symbol on the top right of the app screen.Happy Measuring!